Votronic VAC 2425 M 3A Automatic charger 24 V 25 AVotronic VAC 2416 M 3A Automatic charger 24 V 16 A
Our service
Order hotline
+49 (0)9181 / 330 100Mon. - Sat.: 8:00 - 20:00 hrs
Specialist advice
ARRANGE CALLBACKMon. - Fri.: 9:00 - 16:00 o'clock
Secure payment with SSL encryption
Free return
Up to 5% bonus with the Berger advantage card
Product details
| Specially adapted to emergency vehicles | 8 loading programs adjustable |
| Battery capacity adjustable | Electronics moisture protected |
Product description
Details
- Charging programs No. 1, 2, 3 and 5 (Gel, AGM, Acid, Start) adjustable to battery type
- Charging voltage is free of peaks and regulated to prevent overcharging of batteries.
- Fully automatic continuous operation: the charger can be constantly connected to the battery and keeps it at full charge. In case of mains failure, the batteries are not discharged (disconnected by safety switch).
- Lead-acid battery regeneration twice a week during long periods of standing against harmful acid stratification.
- Parallel and buffer operation: In case of simultaneous consumption, the battery is further charged or kept full. The charger automatically calculates and monitors the adjustment of the charging times.
- monitoring-free charging: Multiple protection against overload, overheating, overvoltage, short-circuit, reverse polarity, malfunction and battery back-discharge by electronic cut-off up to complete disconnection of charger and battery by built-in safety switches.
- Connection for battery temperature sensor (temperature sensor 825 included): For lead-acid batteries (acid, gel, AGM), automatic adjustment of the charging voltage to the battery temperature, causes a better full charge of the weaker battery in cold weather, in summer temperatures, unnecessary battery gassing and thus battery stress is avoided.
- Silent Run function: Noise-optimized operation at the touch of a button (night operation).
- Power supply function: Enables consumers to be supplied without a battery (e.g. when changing batteries).
- Charging cable compensation: Voltage losses on the charging cables are automatically compensated.
- Built-in on-board power supply filter: Problem-free parallel operation with solar systems, wind and gasoline generators, alternators, etc. on one battery.
- Electronics moisture-protected
- Charging aid for deeply discharged lead batteries: Gentle pre-charging of the (lead-acid, -gel, -AGM) battery up to 8 V, then powerful support of the battery with consumers possibly still switched on.
- Built-in charging current distributor with 2 main charging outputs, both with max. current and power capacity
- In case of mixed operation with 1 supply and 1 starter battery, a separate starter charging program can be set on the built-in charging current distributor
- Starter battery is also charged with full charging current if required (short vehicle standing time)
- Separate auxiliary charge output "S" for support and maintenance charging of another starter battery or as signal output +86 for engine start inhibit when vehicle is connected to mains supply
- Equalization function (IUIU charging characteristic can be activated manually for cell equalization charging)
- Disconnection of batteries in case of mains failure, overheating, malfunction (safety switch per charge output)
- Variable installation position
- Additional details for the VAC 2425 M 3A- version
Battery capacity 4-fold adjustable (total 12 charging programs) - Inputs for voltage sensor (sense) lines, optionally usable with overlong charging lines and/or external, lossy diode charging current distributors
- Mains/charging power can be reduced in case of low-power or limited mains supply, e.g. weakly fused shore power, generator operation etc. (power limit function)
- 1 "Gel": Charging program for gel batteries, characteristic IU1oU2oU3: Adapted to sealed, gas-tight gel/dryfit batteries with fixed electrolyte, which generally require a higher charge voltage level and longer U1 holding times to achieve short charge times with particularly high capacity storage and to avoid long-term battery "starvation".
- 2 "AGM": charging program for AGM/non-woven batteries, characteristic IU1oU2oU3: Intended for charging sealed, gas-tight AGM (Absorbent-Glass-Mat) batteries in lead-fleece technology, which require a particularly high U1 level with coordinated holding times for full charging and then a moderate U2 level for charge retention (plate and round cell technology).
- 3 Charging program 3 "DIN 0510" for lead-acid/wet batteries, characteristic IU1oU2oU3: General DIN characteristic for charging and charge retention of open and closed lead-acid batteries with removable cell plugs and the possibility of acid level control and acid level correction (maintenance). Also applicable for closed batteries low maintenance, maintenance free, low antimony, silver alloy, calcium etc. with low or very low water consumption. Provides with high U1 level short charging times, high charging factor and high acid mixing, even in dormant (stationary) use (acid stratification) for "wet" traction, lighting, solar, heavy duty and standard batteries.
- 5 "MOTOR": charging program for lead-acid/wet batteries, characteristic IU1oU2oU3: characteristic similar to alternator/generator for moving (mobile) use (acid stratification) with particularly low maintenance (battery gassing, water consumption). Charging and charge maintenance of starter batteries in emergency vehicles, according to an earlier proposal of the Fire Service Standards Committee (FNFW). For conventional standard starter batteries, starter batteries "Absolutely maintenance-free", "Maintenance-free according to EN", "Maintenance-free according to DIN", "Maintenance-free", "Low maintenance".
- BR: Automatic battery regeneration
- DC: Power supply function (battery replacement)
- Equalization function (cell equalization charge)
- FB: Remote control/display connection
- LV: Charge current distributor for one or more batteries
- SR: Silent Run function (night setback)
- TK: Temperature compensation
- TS: Temperature sensor included
- Electronics moisture-proof
- Additional features for the VAC 2425 M 3A- version
- Kap: Battery capacity (-size) adjustable
- PL: Power limit function mains/charging power reduction
- VF: Voltage sensor (for very long charging lines)
- Rated voltage (AC) in [V] 230
- Operating voltage range (AC) in [V] depending on version
- Power consumption (AC) in max. [W] depending on version
- Sinusoidal power factor correction (CosPhi = 1): yes
- Nominal battery voltage (DC) in [V]: 24
- Secondary charge output "S" in [A] depending on version
- Charging characteristic: IU1oU2
- Voltage limitation for all charge modes/programs [V]: 30
- Voltage ripple in [mV] rms: < 50
- Number of charge outputs depending on version
- Device mounting position: any
- Temperature range [°C]: -20 to +45
- Degree/class of protection I / IP: 21
- Dimensions incl. mounting flanges, without connections depending on version
- Ambient conditions, humidity: max. 95% room humidity, non-condensing
- For further technical data please refer to the operating instructions
- Power cable,
- 1 temperature sensor for VAC 2416 M 3A- version
- 2 temperature sensors for the VAC 2425 M 3A- version
- Operating instructions
Features
| Type battery | Charger |
| Operating voltage | 24 V |
| Design | VAC 2425 M 3A |
| Weight | 2400 g |
| Dimensions (LxWxH) | 160 x 305 x 71 mm |
| Battery capacity | 46 - 290 Ah |
| Input voltage | 190 - 265 (full charging power) |
| Charging current | 25 A |
| Output | 830 W |
Features
| Type battery | Charger |
| Operating voltage | 24 V |
| Design | VAC 2416 M 3A |
| Weight | 1450 g |
| Dimensions (LxWxH) | 160 x 210 x 71 mm |
| Battery capacity | 40 - 200 Ah |
| Input voltage | 190 - 265 (full charging power) |
| Charging current | 16 A |
| Output | 520 W |
Note
Please note: since our deliveries may contain batteries (single-use and rechargeable),
according to the German Law on Batteries (BattG) we must advise you of the following:
single-use and rechargeable batteries must not be disposed of along with domestic waste, but rather you are legally required to return used batteries. Used batteries may contain damaging substances which, if not stored or disposed of appropriately, may damage the environment or your health. Batteries may, however, also contain important raw materials, such as, for example, iron, zion, magnesium or nickel, which can be recycled. Once used, you may either send the batteries back to us, or return them in
your vicinity (e.g. at the shop, communal recycling points or at our expedition warehouse) - free of charge. When returning used batteries to points of sale, the quantity you are allowed to return is limited to the quantity typical for a single end user, and to those batteries which the seller offers or used to offer in their product range.
The symbol with a rubbish bin crossed out means that you must not dispose of single-use and rechargeable batteries
along with the domestic waste. Underneath this symbol you will also find the following symbols which have the following
meanings:
Pb: battery contains lead
Cd: battery contains cadmium
Hg: battery contains mercury
Return address:
Fritz Berger GmbH
Fritz-Berger-Str. 1
D - 92318 Neumarkt
Note
Please note: since our deliveries may contain batteries (single-use and rechargeable),
according to the German Law on Batteries (BattG) we must advise you of the following:
single-use and rechargeable batteries must not be disposed of along with domestic waste, but rather you are legally required to return used batteries. Used batteries may contain damaging substances which, if not stored or disposed of appropriately, may damage the environment or your health. Batteries may, however, also contain important raw materials, such as, for example, iron, zion, magnesium or nickel, which can be recycled. Once used, you may either send the batteries back to us, or return them in
your vicinity (e.g. at the shop, communal recycling points or at our expedition warehouse) - free of charge. When returning used batteries to points of sale, the quantity you are allowed to return is limited to the quantity typical for a single end user, and to those batteries which the seller offers or used to offer in their product range.
The symbol with a rubbish bin crossed out means that you must not dispose of single-use and rechargeable batteries
along with the domestic waste. Underneath this symbol you will also find the following symbols which have the following
meanings:
Pb: battery contains lead
Cd: battery contains cadmium
Hg: battery contains mercury
Return address:
Fritz Berger GmbH
Fritz-Berger-Str. 1
D - 92318 Neumarkt
Our service
Order hotline
+49 (0)9181 / 330 100Mon. - Sat.: 8:00 - 20:00 hrs
Specialist advice
ARRANGE CALLBACKMon. - Fri.: 9:00 - 16:00 o'clock
Secure payment with SSL encryption
Free return
Up to 5% bonus with the Berger advantage card
