Büttner Elektronik CDS Power Line MT complete solar system

CDS Power Line complete systems include all installation accessories. Each system is equipped with high quality individual components in a high quality finish. All solar modules of the CDS Power Line series are equipped with the absolute best monocrystalline high-performance cells available on the market. The absolute highest performance is guaranteed on a small area, even under the most difficult operating conditions.

The solar modules are mounted on TÜV-tested brackets. These are glued to the vehicle roof with the enclosed adhesive set (tested and approved by TÜV). The outer cable is UV-safe and, like the cable set in the interior, resistant to all environmental influences. The cable connection to the interior is routed through a pressurized water-tight cable bushing.

The cabling is designed in such a way that the system can be subsequently expanded by a solar module of the same power at any time. The solar control system can also handle the additional power.

All complete systems (up to max 15 A) are also equipped with an EBL connection cable set and are therefore state-of-the-art. The installation set is supplemented by the required installation material and detailed installation instructions.

The clever solution Bonding instead of screwing!
Nobody likes to drill unnecessary mounting holes in their motorhome roof. Moreover, it makes little sense, since the thin roof skin with its insulation does not guarantee high screw strength anyway. That's why we built high-quality brackets 20 years ago and developed a system for bonding them securely to the vehicle roof without drilling. The solar modules are then screwed onto these roof spoilers and can also be easily replaced when the vehicle is changed. The roof spoiler and roof bushing are not made of ABS material, but of high-quality polyurethane (PUR). They are therefore extremely weather-resistant and will last the life of a motorhome. To prevent wind noise and lift forces, our system was additionally tested and optimized in the wind tunnel. Since the retaining system itself has met the strict DIN standard, the system has been approved by TÜV for bonding to motorhome roofs. Further information

High performance in a small area
From a technical point of view, the CDS Power Line solar modules are the measure of all things in motorhome construction. Absolute maximum performance - even under the most adverse operating conditions - is realized by an innovative glass surface in combination with selected high-performance cells. However, these monocrystalline high-performance cells are not connected in series - as is usually the case - but in series with 44 cells. Each individual cell is additionally connected with a special cell diode to ensure that the highest possible power output can be achieved even when the solar module is partially shaded. Since CDS modules are constructed with 44 high-performance cells, an MPP solar controller should always be used. This guarantees an optimal yield in every application area due to the increased output voltage of the CDS modules. With this control technology, the highest yield can always be realized when the module voltage is and remains very high even at high outside temperatures. CDS Power Line solar modules in combination with a MPP solar controller achieve the highest performance values in any climate zone on the smallest area, even in unfavorable weather conditions.

Details

• AGM LiFePO4 + Gel suitable
• Performance advantages in unfavorable weather conditions
• mpp control technology
• Specially designed for touring vehicles
  • Solar modules for mobile homes and caravans are subjected to different stresses than those for domestic systems! For example, for mobile use, the junction boxes must be pressure water-tight (driving wind) and the soldered connections must be specially designed for the vibrations that occur. The frame construction also requires a special design to compensate for any torsion and uplift forces that may occur.
• Bonding and mounting: TÜV tested + approved
  • The mounting system has met the strict DIN standard and has been approved by TÜV for bonding to motorhome roofs.
• Solar module removable
  • When the vehicle is sold, the solar module can be removed from the base mount and reassembled on the new vehicle.
• Small area / high power
  • Extremely high performance due to selected raw material

Scope of delivery (ready for installation with all necessary components for roof mounting)

• 1 or 2 x CDS POWER LINE solar module/s
• 1 or 2 x spoiler profile set/s
• 1 x roof gland (waterproof)
• 1 x cable gland (waterproof)
• 1 x MPP charge controller (see below)
• 1 x cable connector strip
• 1 x adhesive set
• 1 x UV cable set/outdoor area
• 1 x cable set/indoor
• 1 x EBL cable set (depending on power)
• 1 x mounting material
• Adhesive instructions
• Mounting instructions