Pipe Systems & Pipe Connectors
Pipe Systems And Connecting Pieces create a secure, hygienic water supply in caravans and motorhomes. Choose compatible pipe diameters, push-fit connectors and BSP adapters to build tidy runs with leak-tight joints. With the right connecting pieces you can route fresh water efficiently, simplify maintenance and keep flow consistent on every trip.
Read more about Pipe Systems & Pipe Connectors ...
Pipe Systems And Connecting Pieces
A dependable pipe system keeps fresh water moving safely from tank to tap. By matching pipe diameters, materials and connecting pieces such as elbows, tees and reducers, you can create neat runs, reduce pressure loss and prevent leaks. Plan access points and isolation valves so servicing is quick at the pitch or on the road.
Caravan And Motorhome Pipe Systems Basics
Begin with food-grade pipe sized to your pump and appliances. Semi-rigid pipe offers stable routing in lockers, while flexible hose helps around tight corners. Keep diameters consistent where possible and avoid unnecessary transitions to maintain steady pressure and quiet operation.
Fresh Water Pipe Routing In Connecting Pieces
Use gentle curves and the shortest practical runs. Where bends are unavoidable, fit 45° or 90° elbows to prevent kinks and preserve flow. Support pipe every 30–50 cm with cushioned clips to reduce vibration and chafe.
Choosing Materials For Pipe Systems
Select temperature-resistant, food-grade plastics for drinking water lines and corrosion-resistant metals only where specified. Verify compatibility with disinfectants and winterising agents before purchase.
Push-Fit Connecting Pieces And Quick Assembly
Push-fit couplers, elbows and tees speed up installation and future upgrades. Deburr pipe ends, mark insertion depth and push fully home to ensure a leak-tight seal. Use colour-coded pipe for hot and cold to make troubleshooting easier later.
Reducers And Adapters In Pipe Systems
When mixing sizes, choose smooth-bore reducers sized to your layout to minimise restriction. Keep adapters to the minimum needed to reduce potential leak points.
BSP Threads And Sealing For Connecting Pieces
Many taps, filters and inlets use BSP threads. Confirm male/female orientation, add suitable gaskets or PTFE tape and avoid overtightening to protect seats and O-rings.
Distribution Manifolds And Isolation Valves
Compact manifolds create tidy branches to kitchen, bathroom and exterior showers. Fit isolation valves before taps and appliances so individual lines can be serviced without draining the entire system.
Non-Return And Shut-Off Connecting Pieces
Inline check valves prevent backflow from elevated tanks, while slim shut-off valves add control at key branch points for quick repairs.
Frost Protection For Pipe Systems And Connecting Pieces
Low-point drain valves help empty pipework before freezing conditions. In colder months, consider thermostatic frost valves that open automatically to protect vulnerable sections from burst damage.
Winterising Checks For Pipe Systems
Open mixer taps to mid position so hot and cold circuits vent, drain appliances per manufacturer guidance and cap external inlets to keep debris out during storage.
Waste Water Pipe Systems And Odour Control
Route grey-water pipes with a gentle fall to the tank or drain to avoid standing water. Add water traps near sinks and keep vents clear for smooth, gurgle-free flow.
Securing Connecting Pieces In Waste Lines
Use temperature-resistant pipe and secure with clips at regular intervals. Inspect joints periodically and replace tired seals to prevent drips and smells.
Maintaining Your Pipe Systems On The Road
Carry spare O-rings, a few universal couplers, a short length of pipe and quality clamps. Pressure-test after changes, clean lines periodically and consider in-line filtration to maintain taste and water quality throughout the season.
