Votronic charge converter VCC 24-25 IUoU
Item no: VotronicLadeWandlerVCC2425IUoU390717
0,- €
Prices incl. statutory VAT,
plus shipping
Get up to 5% Bonus with the Berger Loyalty Card
€ Bonus with the Berger Loyalty Card
Product details
| Fully automatic operation | Automatic, adjustable power control | No discharge | Surveillance free charge |
Product description
Fully automatic battery charge converter for special vehicles, motorhomes, boats.
The marine versions are additionally equipped with moisture-proof electronics.
Details
Operating instructions
The marine versions are additionally equipped with moisture-proof electronics.
Details
- High charging power even for short driving distances
- Significantly improved energy balance of the supply circuit
- Excellent protection of the supply battery and the consumers connected to it against the sometimes very strong voltage fluctuations of dynamically controlled alternators in newer vehicles
- During longer journeys, the IU1oU2 charging technology achieves a full charge, thereby eliminating overcharging
- Optimum charging characteristics for 4 battery types adjustable by battery selector switch (acid, gel, AGM1, AGM2)
- Automatic, adjustable charging power ensures priority charging of the starter battery by the alternator when the vehicle electrical system is under heavy load, thus ensuring that the vehicle can be started again immediately
- In the event of simultaneous consumption in parallel and buffer mode, the battery continues to be charged or maintained full. The charge converter automatically calculates and monitors the adjustment of the charging times.
- Built-in temperature compensation automatically adjusts the charging voltage to the battery temperature independently of the alternator; battery temperature sensor Art. 2001 required
- Easy installation, no intervention in the vehicle starter circuit required, device is connected in the charging line to the supply battery.
- Safety protection and protection against reverse polarity, short circuit and back discharge
- Connection for remote control art. 2075, remote operating display IP67 art. 2081 or Charger State Monitor IP67 art. 2082
- Also prepared for operation with EBL (electrical block) and EVS (only VCC 1212-25 IUoU-Li and VCC 1212-45 IUoU-Li).
- Built-in on-board power supply filter enables trouble-free parallel operation with solar systems, mains chargers and other charging sources on one battery
- Galvanic isolation between input and output ensures excellent suppression of interference due to absolute separation of the battery circuits, clean ground conditions on both sides even with long supply lines, safety in the event of a fault (no breakdown 12V/24V or 24V/12V possible) and reliably prevents unwanted reverse discharges of the battery circuits
- Switching input for fully automatic controlled operation (ignition, D+ engine running) or optionally manually controlled by remote switch
- Measurement input optionally enables pure voltage control of the device if required
- The unit application range also extends to clean battery charging further away from the alternator in large vehicles, trailers, utility containers, etc.
- 1 "Gel": charging program for gel batteries, characteristic IU1oU2: Tuned to sealed, gas-tight gel/dryfit batteries with fixed electrolyte, which generally require a higher charging voltage level and longer U1 holding times to achieve short charging times with particularly high capacity storage and to avoid long-term battery "starvation".
- 2 "AGM": Charging program for AGM/fleece batteries, characteristic IU1oU2: Intended for charging sealed, gas-tight AGM (Absorbent-Glass-Mat) batteries in lead-fleece technology, which require a particularly high U1 level with coordinated holding times for full charging and then a moderate U2 level for charge retention (plate and round cell technology).
- 3 "DIN 0510": Charging program for lead-acid/wet batteries, characteristic IU1oU2: General DIN characteristic for charging and charge maintenance of open and closed lead-acid batteries with removable cell plugs and the possibility of acid level control and acid level correction (maintenance). Also applicable for closed batteries low maintenance, maintenance free, low antimony, silver alloy, calcium etc. with low or very low water consumption. Provides with high U1 level short charging times, high charging factor and high acid mixing, also in dormant (stationary) use (acid stratification) for "wet" traction, lighting, solar, heavy duty and standard batteries.
- 4 "UNIVERSAL": Charging program for lead-acid/wet/AGM batteries, characteristic IU1oU2: Universal program for charging and charge maintenance of acid batteries in vehicles (mixed mobile/stationary). With medium U1 level, still provides short charge times, good charge factor and good acid mixing for open and closed, low-maintenance, maintenance-free standard, traction, lighting, solar and heavy duty batteries, as well as AGM batteries with normal U1 level.
- Battery type adjustable: acid, gel, AGM1, AGM2
- Power consumption IN max. in [W]: 800
- Nominal battery voltage OUT in [V]: 24
- Battery capacity OUT recommended/up to in [Ah]: 50 - 170 / 220
- Charging characteristic: IU1oU2
- overvoltage cut-off: yes
- Voltage ripple in [mV] rms: < 50
- Charge timer: 3-fold
- Device mounting position: any
- Temperature range [°C]: -20 to +45
- Degree/class of protection: IP 21
- Dimensions (W x H x D) incl. mounting flanges, without connections in [mm]: 160 x 71 x 245
- Ambient conditions, humidity: max. 95% room humidity, non-condensing
Operating instructions
